Tutorial written by Nemesis
For this tutorial you will need:
Flaming pear - Glitterato
The Fonts I used are called :
Vrinda - free font
Antelope H - freeware font
This tube was made by me in poser.
©Info on a second layer. Use it, thank you @-}}--
***Install the tube and the fonts.***
-If the settings aren't shown they are default settings.-
Open up a new image 160*245 pixels with a transparent background.
Select your flood fill tool and flood fill with black.
Now go to effects/ plugins/ flaming pear/ glitterato.
Add with the following settings...
Now go to image add borders, tick symmetric, set colour to white and
add with a 1 pixel width.
Then Width 1 pixel colour: #87685b
Width 1 pixel colour: white
Width 3 pixel colour: black
Width 3 pixel colour: white
Width 5 pixel colour: black
When u're done you should have something looking like this...
Select your text tool, background colour: white and line width set to 0.
The font is called Antelope H, set font size to 72, kearning to -535.
Tick Direction, vertical and right.
Add your name. The text will be way to big for your tiny canvas
so select the raster deform tool and use the handles to push the
text down to fit. Like this...
Now lower the opacity on this layer to 70% (this is done on the layer palette)
Then select your selection tool set to rectangle and replace.
Select half of your text downwards, Like so...
Click on the selection then click and hold down.
Move half your text to the right (about 14 pixels).
This can be edited later so don't worry .
Deselect by pressing ctrl + d.
Add a new raster layer (layers/ new raster layer)
Select your text tool, change font to Vrinda, set size to 10.
Set kearning to -268, Antialias: Off and text direction: vertical and left.
Type in your name about 5 times ( depending on how long it is).
Then go to image/ rotate / free rotate and rotate with 90 degrees to the left.
Deselect, and use your mover tool to move the text into place.
Add a new raster layer.
Now select your Pen tool, set foreground colour as white.
Line width set to 1, antialias ticked and then tick draw lines and polylines.
Untick create on vector and then draw a line from the inner white boarder top
to bottom. Hold down the shift key while you draw to create a perfectly straight line.
Duplicate this layer (layers/ duplicate). Then use the mover tool to move them
both into place. You should now have something looking like this...
Go to layers/ merge / merge visible.
Then go to image/ canvas size and set new dimensions to 400*400 pixels.
Add a new raster layer and add the tube with the size 45%.
Now go to effects/ 3d effects/ drop shadow and add with these settings...
Now merge visible again and add another drop shadow with these settings...
Now add the ©info that comes with the tube.
Merge flatten and crop ! Weeeee! You're done !
I hope you had fun.
Please feel free to link to this tutorial,
and/or print it out for your own personal use,
but do not copy it in any way to put on-line, pass out,
or re-write without my permission.
Copyright © Nemesis Tutorials